Open sandynomad opened 8 years ago
While the RHEL Docs clearly state this, /usr/sbin/ifup
on CO7 includes the 'global' /etc/sysconfig/network
file upon starting (not sure about other distros in the rhel family).
For VLANs to be activated it is sufficient to use it only once in this file, and then all adapters that are matching MATCH='^.+\.[0-9]{1,4}$'
and are not an alias will get the VLAN-ID from that match attached.
There is a risk because the VLAN matching will be done for each interface on the host when VLAN=yes
is set in the 'global' /etc/sysconfig/network
file. This might have implications on other interfaces named that way by accident, choice or habit.
I would suggest to either add define network::if::vlan
or allow "VLAN=yes"
to be set on interface level while removing it from global entirely.
Configuration file for an interface with a VLAN (ie: ifcfg-enp6s0f0.330) appears to be missing 'VLAN=yes'
The following config:
network::if::static { 'enp6s0f0.330': ensure => 'up', ipaddress => '10.2.3.248', netmask => '255.255.255.0', }
Generates:
File managed by Puppet
DEVICE=enp6s0f0.330 BOOTPROTO=none HWADDR=.... ONBOOT=yes HOTPLUG=yes TYPE=Ethernet IPADDR=10.2.3.248 NETMASK=255.255.255.0 PEERDNS=no NM_CONTROLLED=no
However the mandatory variable 'VLAN=yes' is missing.
Refer to:
https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Networking_Guide/sec-Configure_802_1Q_VLAN_Tagging_Using_the_Command_Line.html#sec-Setting_Up_802.1Q_VLAN_Tagging_Using_ifcfg_Files