Closed easyw closed 2 years ago
hi, (recently) kicad v5.99 has switched to write gr_arc as start mid end instead of start end angle
gr_arc
start mid end
start end angle
kv5 (gr_arc (start 41.656 73.533) (end 39.878 73.533) (angle -90) (layer Edge.Cuts) (width 0.05) (tstamp 5C908375))
(gr_arc (start 41.656 73.533) (end 39.878 73.533) (angle -90) (layer Edge.Cuts) (width 0.05) (tstamp 5C908375))
kv6 (5.99) (gr_arc (start 41.656 75.311) (mid 40.398764 74.790236) (end 39.878 73.533) (layer "Edge.Cuts") (width 0.05) (tstamp 00000000-0000-0000-0000-00005c908375))
(gr_arc (start 41.656 75.311) (mid 40.398764 74.790236) (end 39.878 73.533) (layer "Edge.Cuts") (width 0.05) (tstamp 00000000-0000-0000-0000-00005c908375))
round-corners-kv5.zip round-corners-kv6.zip
Would it be possible to accept both formats?
@realthunder Thx! 😸
easyw
commented
2 years ago easyw
commented
2 years ago
hi, (recently) kicad v5.99 has switched to write
gr_arcasstart mid endinstead ofstart end anglekv5
(gr_arc (start 41.656 73.533) (end 39.878 73.533) (angle -90) (layer Edge.Cuts) (width 0.05) (tstamp 5C908375))kv6 (5.99)
(gr_arc (start 41.656 75.311) (mid 40.398764 74.790236) (end 39.878 73.533) (layer "Edge.Cuts") (width 0.05) (tstamp 00000000-0000-0000-0000-00005c908375))round-corners-kv5.zip round-corners-kv6.zip
Would it be possible to accept both formats?