Waouh!
I just found your project looking for an open source resolver to interface old sin/cos linear encoders on a CNC.
I'm very impressed by your design and I will consider using it to replace the electronic of a CB Ferrari F40 using DC brushed motos. One of the problem is the feedback with tacho+linear encoders...
Do you know if the actual electronic (mainly the IRF driver) is able to support large motor deceleration without shunt regulation?
Just in case, do you sell PCB?
Congratulation and many thanks for your work.
Eric.
Ps. I'm a RF IC design engineer focused in low power design, but I will learn how to drive amps ;)
Waouh! I just found your project looking for an open source resolver to interface old sin/cos linear encoders on a CNC. I'm very impressed by your design and I will consider using it to replace the electronic of a CB Ferrari F40 using DC brushed motos. One of the problem is the feedback with tacho+linear encoders... Do you know if the actual electronic (mainly the IRF driver) is able to support large motor deceleration without shunt regulation? Just in case, do you sell PCB? Congratulation and many thanks for your work. Eric. Ps. I'm a RF IC design engineer focused in low power design, but I will learn how to drive amps ;)