Open repentsinner opened 3 years ago
Dammit, meant to run a higher current (~10A) always-on to the dash for aux use in addition to control signal source, but forgot to put a heavier gauge conductor in the run from driver side cargo to dash. :(
Engine bay is done for now, all existing sensors and devices changed to use new signal bus.
Driver side cargo panel is 80% done, 4 device relay block installed and tested, just need to finish connecting to bumper lights as first device.
Well shit, while I was making the harness to the rear driver cargo panel I totally forgot to pull a line from the high beam circuit over to the dash to trigger the eventual driving lights. That was dumb.
bumper lights re-wired and connected. driver side cargo panel bus is done for now.
Related to #30.