Open Biker1bob opened 1 month ago
I built a set of 5 from jlcpcb. I am in Canada. I am using a 1040STE 1.06 tos. I have now flashed 2 of the 5 I had made. Both worked for a boot or two. Now both are stuck with activity light on. Computer does not see anything at the ACSI port.
Used std oni flash 5.0a - used UART CH340 to flash - used STM32CUBE to flash - all says was good, flashed again.. verified.. all good.
I have multi micro SD cards around. I have tried a bunch. Again worked for a boot or two etc.. but now both of these boards are stuck with ACT led on - nothing seen nothing detected etc.
This is the computer I run my bbs on - acsi port works fine with Ultra Satan.
James
I have a v5.0a that now I cannot get to work at all. Do you want that kind of thing here? Is there a forum/thread/discord..etc..etc.. that I can get help with this? It is a JLCpcb built board.
James