Thanks for the PR! I did not know about this holder, and it's great to see support for another board, especially a wireless one!
This external holder is taller than the other holders, so it will not fit into the model. I'd prefer to link to ones that are all the same size rather than add an extra setting to configure the height of the cutout. I'm sorry for creating new rules about the connectors page after you've submitted your PR.
I'm going to reject the PR, but I'll make a note of this holder's existence on the page.
Thanks for the PR! I did not know about this holder, and it's great to see support for another board, especially a wireless one!
This external holder is taller than the other holders, so it will not fit into the model. I'd prefer to link to ones that are all the same size rather than add an extra setting to configure the height of the cutout. I'm sorry for creating new rules about the connectors page after you've submitted your PR.
I'm going to reject the PR, but I'll make a note of this holder's existence on the page.