I have a Fibaro double switch 2. I am atempting to link this with a smartthings hub. I install the device handler as per Fibaro's instructions. I follow the link process i.e. toggle S1 three times and the switch appears. However I still cannot connect to ch2 (S2) and within the smartthings app it is saying "checking status" and has said this since installation. I've tried Fibaro's recommended steps to reset the device with still no luck. Is it the code as when I try to simulate via Smartthings IDE I get a validation error?
I have a Fibaro double switch 2. I am atempting to link this with a smartthings hub. I install the device handler as per Fibaro's instructions. I follow the link process i.e. toggle S1 three times and the switch appears. However I still cannot connect to ch2 (S2) and within the smartthings app it is saying "checking status" and has said this since installation. I've tried Fibaro's recommended steps to reset the device with still no luck. Is it the code as when I try to simulate via Smartthings IDE I get a validation error?