Closed S57PNX closed 5 days ago
hi,
did you by chance test it a little further?
I rebuilt from the latest code and tried again, same behaviour. The keyboard backlight blinks shortly and nothing comes on screen, I can't use Monitor because the USB port quickly disconnects and reconnects (less than 1 second) continuiusly. I get the windows USB connect/disconnect sound uninterrupted.
did you use the "enable" flashing process with the buttons:
use/boot button (middle button of the joystick) and RESET?
as recomended for any ESP32S3 board?
Yes, I put the t-deck in the flashing mode by holding joystick button while resetting. The board connects in a stable mode and I am able to do a full upload of firmware and filesystem, no error messages. After I reset it, it goes in normal operation mode, but it doesn't boot and does rapid cycle of usb disconnect/reconnect.
This unit worked OK with a firmware from early May.
Can anybody else test with their t-deck?
I've tested and it was broken with Espressif version 6.7.0
so after a few mods and T-deck to Espressif version 6.3.1 it works again
Confirm, this fixed it for me too! Thank you.
On 27 Jun 2024, at 21:00, Ricardo Guzman (Richonguzman) @.***> wrote:
Closed #121 https://github.com/richonguzman/LoRa_APRS_Tracker/issues/121 as completed.
— Reply to this email directly, view it on GitHub https://github.com/richonguzman/LoRa_APRS_Tracker/issues/121#event-13322285827, or unsubscribe https://github.com/notifications/unsubscribe-auth/BHDLO6EX2FOUWTU7U3ERQJLZJROLBAVCNFSM6AAAAABI7DW3BOVHI2DSMVQWIX3LMV45UABCJFZXG5LFIV3GK3TUJZXXI2LGNFRWC5DJN5XDWMJTGMZDEMRYGU4DENY. You are receiving this because you authored the thread.
Can anybody confirm that their T-Deck still works after last code changes? I updated an early May FW to latest source code, and it doesn't boot anymore - symptoms are constand disconnect and reconnect to usb, nothing on screen.
I had to boot it in the bootloader mode (pushing trackpad during power up), then uploaded Firmware and Filesystem. Won't start up afterwards with this rapid USB disconnect and reconnect. I even installed meshtastic just to double check the hardware and it works OK.