search

richonguzman / LoRa_APRS_Tracker

LoRa APRS Tracker with Tx and Rx capabilities, Messages, Wx, Winlink and more...
MIT License
168 stars 45 forks source link

LILYGO SX1262 T-Beam AXP2101 v. 1.2 problem #92

Closed SP9MIB closed 1 month ago

SP9MIB commented 2 months ago

Hello,

After build, upload and upload filesystem image, I've got this on my terminal:

rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0x3fff0030,len:1184 load:0x40078000,len:13192 load:0x40080400,len:3028 entry 0x400805e4 [INFO][AXP2101] init done!

The message loops and appears over and over again.

What is the problem? My device is: LILYGO SX1262 T-Beam AXP2101 v. 1.2 (without screen).

Best regards, Piotr

richonguzman commented 2 months ago

Hi

Did you upload with the correct environment selection for this board?

SP9MIB commented 2 months ago

Hi :)

I choose PlatformIO and "ttgo-t-beam-v1_2_SX1262", upload and monitor.

richonguzman commented 2 months ago

this both for firmware and filesystem ?

f4exb commented 1 month ago

I had the issue until flashing the filesystem. It worked fine after this.