2024-04-13 version - Githubissues

richonguzman / LoRa_APRS_iGate

LoRa APRS iGATE for ESP32 Based Board with Rx + Tx capabilities

MIT License

208 stars 65 forks source link

2024-04-13 version #77

Closed iw2ejh closed 3 months ago

iw2ejh commented 5 months ago

today I updated my Solar test digi +WX and noticed a few things:

in the digi+WX, if the BME is disconnected the digi/iGate do not start and display "error, BME configured but BME missing" would it be possible to bypass this, and have the digi working even in case the BME lost connectivity or get damaged?
the display is not shutting down even if selected.
I enabled "power saving mode", and system "shut down at low level:". When I write the level, how the parameter is written? with coma, or point? with decimal? I put 3.2 with a point and one decimal but not sure it is the right format.
The wiki warm about carefull connection to monitor external battery, and indicate to check for a specific information. But in fact this specific information is missing (or I couldn't found) Thanks for the great job iw2ejh

richonguzman commented 5 months ago

1) good idea... will check it out 2) will check it out 3) with "." always 4) where does it say specific information? do you mean about voltage divider?

iw2ejh commented 5 months ago

#"where does it say specific information? do you mean about voltage divider?"

In the wiki, https://github.com/richonguzman/LoRa_APRS_iGate/wiki/11.-VSCODE-iGate-Configuration
-OTHER
- "externalVoltageMeasurement" : true will measure a 12V battery through a voltage divider resistor net and send its Voltage to APRS-IS. Default is false. Look for special info on this Wiki to connect the battery and voltage divider to avoid burning the board.

-but I cannot found other special info.

richonguzman commented 5 months ago

between all the changes this was moved and deleted... will add it soon

meanwhile:

its a voltage divider for external voltage measurement. Max Voltage to read 15v resistor 1: 100K (between + of battery to ESP32 pin) resistor 2: 27K from ESP32 pin to GND

oe5reo commented 5 months ago

In "Received Packets" the last 20 received packets should be listed, but here on my end it only shows 11.

The "Received Packets" list also has a long delay time ... received packets (e.g. from my own tracker) are sent to APRS-IS immediately, but in the list these packets appear much later (sometimes up to 30 minutes).

73 Martin OE5REO

richonguzman commented 3 months ago

many things of the list are already done... I have taken notes of the missing ones to add/Check them soon