search

rizacelik / STM32F411CEU6_INAV_Firmware

STM32F411CEU6 Board Firmware
124 stars 33 forks source link

ExpressLRS or serial base receiver support? #3

Closed wittzer closed 9 months ago

wittzer commented 2 years ago

Thanks for the awesome project! Currently I have expresslrs module on hand and I wish to give it a try. It is serial based TX/RX receiver. may i know where can I wire it?

rizacelik commented 2 years ago

PA3 PIN -> RX

You can also use the SOFTSERIAL_1 pins.

SOFTSERIAL_1_TX_PIN PB6 SOFTSERIAL_1_RX_PIN PB7

You need to set the receiver protocol for SOFTSERIAL_1 from the control panel.

Agusg666 commented 2 years ago

my elrs on pins A2, A3. vtx tbs smart audio pin B6 for setting power fvp via oled display

rizacelik commented 2 years ago

Your explanation is insufficient, I don't understand.

Agusg666 commented 2 years ago

my assembly expresslrs pin rx tx to pA3 and pA2 Full telemetry seen on my tx fsi6(build erfly6). i added oled display scl sda to set the power on vtx to my liking 25mw to 500mw to pin PB6(smart audio) and so far no bugs, it's perfect on inav 4.0 . I don't want it on inav 5.0 , thanks to the inav firmware you made. Greetings from Indonesia to you and your family, may you always be healthy.

Pada tanggal Min, 5 Jun 2022 22.25, Rıza Çelik @.***> menulis:

Your explanation is insufficient, I don't understand.

— Reply to this email directly, view it on GitHub https://github.com/rizacelik/STM32F411CEU6_INAV_Firmware/issues/3#issuecomment-1146833818, or unsubscribe https://github.com/notifications/unsubscribe-auth/APDNX7PKZELFDI3OKSBCWT3VNTBGJANCNFSM5XTZMKIQ . You are receiving this because you commented.Message ID: @.***>