search

rizacelik / STM32F411CEU6_INAV_Firmware

STM32F411CEU6 Board Firmware
122 stars 32 forks source link

One motor is getting hot #44

Open Karan1rao opened 4 months ago

Karan1rao commented 4 months ago

Recently I noticed that one motor (back left) is getting hot despite changing motor and esc, I wonder what could be the issue

rizacelik commented 4 months ago

Which motor pin?

Karan1rao commented 3 months ago

the one at the B6 pin

mursa1en commented 3 months ago

I have also lost a motor and recently an esc using this pin (b6)

Karan1rao commented 3 months ago

hoping rizacelik could solve this issue, as i have burnt two motors at B6 pins

rizacelik commented 3 months ago
  1. What is the ESC brand you use?
  2. What protocols does it support?
  3. And which protocol did you use in the installation?
Karan1rao commented 3 months ago
  1. Hobbywing Skywalker-40A
  2. My esc are standard esc.
  3. I also use standard protocol
rizacelik commented 3 months ago

Which INAV version did you install?

Karan1rao commented 3 months ago

inav 7.0

rizacelik commented 3 months ago

I will review the software again. I will try to fix this problem in INAV 7.1.

Karan1rao commented 3 months ago

thanks brother!!!

mursa1en commented 3 months ago
  1. What is the ESC brand you use?
  2. What protocols does it support?
  3. And which protocol did you use in the installation?

I was using Favourite Little bee 30A esc on oneshot 125 protocol and the motor was from dji phantom 3 (800 kv). I guess the esc lost was just an accident or co incident. But i lost the motor while setting up the FC. All of a sudden the motor started vibrating and started to smoke.

The firmware was inav 7.0

rizacelik commented 3 months ago

If one or more of the engines is overheating, I recommend you take a look at the explanations in this video. Maybe your problem may be the explanation in this video. https://www.youtube.com/watch?v=eo2sjTNS0pc For INAV. https://www.youtube.com/watch?v=zukTkEER-24