[fluidics] Design a maniold

Current pump-tubing attachment assembly is based on flexible tubing and insertion, with a compression housing. This is a bit fiddly.

Idea:

LPM pumps are designed with an O-ring (of the same material as the internal surface, so no additional material compatibilities) to facilitate incorporating into a manifold. See [https://www.theleeco.com/uploads/2021/11/PDS-129-2018-06-LPMSeriesFixedVolumeSolenoidDispensePump.pdf ]
Design a manifold (fabricate with SLA) where the pumps screw into the manifold (with O-ring providing a seal) and then exits to a 10-32 female port
1/16" tubing is connected with a flangeless 10-32 PEEK Fittings (e.g., [https://www.idex-hs.com/store/fluidics/fluidic-connections/flangeless-fitting-peek-10-32-flat-bottom-for-1-16-od.html] )

Requires: [] Redesign of the Pump assembly

Eliminates: [] Adapter clamp [] 1/8" tubing [] screws/bolts associated with Adapter clamp

rodolfokeesey / Liquid-Handler