search

rommulaner / Anycubic_Vyper_LCD_CE_6.2

Firmware for Anycubic Vyper 3D-printer as Community Edition
37 stars 3 forks source link

LCD Firmware seems flashed correctly but no touch #4

Closed Gman1988 closed 7 months ago

Gman1988 commented 7 months ago

Hi team, just flashed LCD firmware to Anycubic Vyper with your custom firmware and it seems everything went well, after reboot screen shows up and react when I operate with printer using OctoPrint but doesn't react on touch.

I tried with 3 different brand and size sd cards and result seems to be the same.

Any suggestions ?

Thnaks, Paweł PXL_20240205_193119024 MP

rommulaner commented 7 months ago

What version did you use before?

Gman1988 commented 7 months ago

What version did you use before?

Previously I used stock firmware.

From stock I moved to Anycubic_Vyper_MB_CE_6.2 then followed this guide on Anycubic_Vyper_LCD_CE_6.2

rommulaner commented 7 months ago

Then you need to flash the touch calibration config and calibrate the touch. It's all described in the release notes of the LCD.

Gman1988 commented 7 months ago

Then you need to flash the touch calibration config and calibrate the touch. It's all described in the release notes of the LCD.

Ahh now I see, I could not find 6.2.1 release notes :) I will try again

rommulaner commented 7 months ago

https://github.com/rommulaner/Anycubic_Vyper_LCD_CE_6.2/releases/tag/Vyper-CE-6.2.1

Gman1988 commented 7 months ago

https://github.com/rommulaner/Anycubic_Vyper_LCD_CE_6.2/releases/tag/Vyper-CE-6.2.1

Worked like a charm, I apologize for not doing enough searching :) Thanks for being patient!

rommulaner commented 7 months ago

No problem, nice to hear it's working as it should.