Closed KAPTOHKA closed 5 months ago
Hey! Good point, but why should someone change the values during printing? You can't even see the changes on the calibration print properly or need to measure the ringing marks to calculate the frequencies. Is there any other printer that has this functionality? Normally you do some test prints with varied frequencies and figure out the best values and that's it.
Well, why do we need 2 identical RGB
buttons located in one place?
It's better to have a IS
button instead of one of the RGB
buttons and we will get the only printer in the world with the ability to change IS on the fly during printing))), for example for tests...
Let be...
The only thing is that the values are not applied directly after the change. Just switching to the page works as I tested it but at the moment you always have to go back to save the changes and it seems that they are applied immediately, but I'm not 100% sure. It also takes a moment to jump back, maybe because of the save operation. Perhaps an apply button is needed and the code must be changed to save only after click on apply. I must go ab deeper in that.
Implemented in 6.2.2. Currently Pre-Release.
Hi. Sugges adding the
Input Shaping
button to screen #79Tune Other
instead ofRGB
(it is still on the next screen #77Misc. Settings
) to access theInput Shaping
settings during printing or on pause... Let it be...