Closed rusefillc closed 1 year ago
I think more glue is not the solution
Move MAP location nearer to the middle of the board or close to connector, to evade damage during shipping
Like so
I think more glue is not the solution
Besides, no amount of glue will save you. The pins/PCB are stiffer than the glue, so any deflection will result in stress in the pins, not the glue. The pins will snap off, then the glue will bear the load only once that's happened. You need either a stiff urethane glue or epoxy, mechanical connection (ie, bolt), or move the sensor.
@ElDominio says
Move MAP location nearer to the middle of the board or close to connector, to evade damage during shipping
Like so
move the sensor.
I agree, location on the edge seems to be the main issue
@Qwerty-OFF still on the edge :(
@Qwerty-OFF can we move to
so that it's NOT on the edge of the board?
Pictured rev F with too many components around allowing only for small amount of hot glue