test rev G Hall test default configuration with two resistors removed board number 0 C3+C4

[rusefillc]

@ElDominio please confirm that you have a working heat gun @ElDominio please do not use soldering iron to remove R4 @ElDominio please remove R4 using hot air and tweezers from back side. please place R4 into a little bag mark "R4" @ElDominio please remove R23 not too far from R4. please place R23 into a little bag mark "R23"

capacitors stay default

@ElDominio need to run this board as hall on C3+C4

[ElDominio]

Use C3 for CKP and C4 for CMP??

[rusefillc]

@ElDominio yes that the request from what I see

[rusefillc]

@ElDominio please provide a status update for this C3+C4

[ElDominio]

C3+C4 works fine on easy Hall car Lancer with 4B11, tested on all boards.

Not tested on problematic hall 4G93 with split cam+crank

All tests i did on the other ticket were done with the configuration on THIS thread. I did NOT try C7+C4

[ElDominio]

Tried revving on board0 and board2, both worked fine @rusefillc

[ElDominio]

RevG works with Hall/VR