USB horizontal on the side

[BeerMoneyMotorsports]

Please find a way to move this usb area to the edge for external access. Doing this will also eliminate the need for USB pins in the options port which is not a robust solution.

[BeerMoneyMotorsports]

Note, if board layers become an issue, conversion to 4 layer is acceptable.

[BeerMoneyMotorsports]

@Qwerty-OFF to clarify, we want the H72 platform footprint on the H64 at the edge.

[Qwerty-OFF]

Do we need the adapter board? Could it be better to use miniUSB or right angle USB -B?

[stefanst]

I vote right-angle USB-B. It's f-ing sturdy.

[mck1117]

@stefanst you mean like on proteus? is that even possible on this ECU, given its mounting in the car?

[stefanst]

I mean right-angle next to the main connector, just like the adapter board.

[mck1117]

oh, right angle, not vertical, got it :)

[Qwerty-OFF]

Should we kept UA-20PMFP-LC7002 soldering pads?

[mck1117]

I think we should have anyway - in addition to whatever USB is on the board.

[rusefillc]

NB2 board used small USB board to lift the USB because of rear cover stamped case shape. I do not see similar drama on NA6

I believe we can simply JLC horizontal mini or USB-B

[BeerMoneyMotorsports]

please keep the adapter board for now to provide a centered location. I have 30+ adapters to use.

[BeerMoneyMotorsports]

after discussion, we can mount direct to board without adapter board.

[mck1117]

USB-B (big square one) preferred over mini

[Qwerty-OFF]

Please check location of the connector

[BeerMoneyMotorsports]

Will the connector be placed during production? We do not want to use an adapter board. Location is perfect.

[Qwerty-OFF]

The connector is JLC part, it will be installed during production

[BeerMoneyMotorsports]

@Qwerty-OFF approved.