Closed BeerMoneyMotorsports closed 2 years ago
Flex input uses in_sens1 in the hellen input module which ultimately goes to GPIOF-3 on the STM32F4
@andreika-git @mck1117
tested with multiple ECUs, or just one?
@mck1117 just the one. I can attempt to try another
you can also try older firmware since we've touched some of this stuff recently
I have been running on newer firmware(05/04/22) and driven it a good bit with zero problems. So firmware seems to be responsible.
ccccccccccccclosed
I had some issues with flex % today. I was on a 45 minute drive and it went from 75 to 0 and started running lean. It did this 5 times and every time a complete power cycle fixed it. After stopping for an hour or so, i went back home. It did it once in the first 5 minutes and never again.
I now have logs of the occurrence.
https://rusefi.com/online/view.php?log=779
Measured the input with the scope.
There was no change in the signal when the fault occurred. Signal does show intermittent noise at times during operation. Sensor maintains vbatt.