Open rusefillc opened 2 years ago
this was SW configuration issue, not HW issue
@mck1117 says
high side outputs have no diode, so it will make lots of heat and have poor control Should work better with less duty cycle Diode from gnd to switched pin Non-stripe goes to gnd Stripe goes to vvt
hello diode to +12MR, should go to GND
between better PID settings and flipped diode VVT/VTC control is much happier
TODO fix diode on adapter
i have duty cycle change from 5% to 95% of VTC / HS2 and no results on shaft position