Firmware does not work all i get is a bleep when i press the start button

[jabulonboaz]

Thank u for this very good project here and all the documentation on hackaday. I followed every instruction to the letter and the calibration seams to work and got all my offset values and feed them into config.h but when i make and load the firmware to run the motors all i get is the board powering up for a sec when i press the start button i hear a bleep and see the red led flashing for a sec then it all turns off. I tryed uncommenting debug and the workaround line but i get a similar behaviour. What is the issue? Also can u write the exact syntax that u used to send the - L20, R20 comand to the board using minicom please? Thanks

[salviador]

very strange, for safety the joy of the wii nunchuck must be neutral if not the engines do not start