I have the Mercury Streamer V2 from Pi2Design consisted of CM4 is the 8GB LITE.
As advised by you in the previous post, you recommended to flash with SD CARD.
However, in this particular pCP8-Q176+44.img, it can't proceed with the installation.
It the same steps as previous post:
1) Flashed pCP8-Q176+44.img pCP8 program SD card by using Raspberry PI Imager.
2) Plug the SD Card to streamer and boot up it but failed.
3) Used Advanced IP Scanner/DHCP Client list from router-can't locate the streamer IP address
4) Search http://pcp.local/ and nothing.
5) Used PUTTY to connect, failed as well.
May I know is that any of my steps wrong?
I have followed your previous post and successfully installed pCP8-Q264x and pCP8-Q264ax(via usb or SD card-successful)
However, as the CPU temp went to 85deg and often it crash (squeezelite stop running and lms showing "no player"). Hence i decided to downgrade toward Q176
I also tried pCP610-Quantum_DuoGaN_CM4(via SD card Only)- it was successful and CPU temp is 60-63deg
Dear Sam,
I have the Mercury Streamer V2 from Pi2Design consisted of CM4 is the 8GB LITE.
As advised by you in the previous post, you recommended to flash with SD CARD.
However, in this particular pCP8-Q176+44.img, it can't proceed with the installation.
It the same steps as previous post: 1) Flashed pCP8-Q176+44.img pCP8 program SD card by using Raspberry PI Imager. 2) Plug the SD Card to streamer and boot up it but failed. 3) Used Advanced IP Scanner/DHCP Client list from router-can't locate the streamer IP address 4) Search http://pcp.local/ and nothing. 5) Used PUTTY to connect, failed as well.
May I know is that any of my steps wrong?
I have followed your previous post and successfully installed pCP8-Q264x and pCP8-Q264ax(via usb or SD card-successful)
However, as the CPU temp went to 85deg and often it crash (squeezelite stop running and lms showing "no player"). Hence i decided to downgrade toward Q176
I also tried pCP610-Quantum_DuoGaN_CM4(via SD card Only)- it was successful and CPU temp is 60-63deg