Arduino Nano 33 IoT

[skuppens]

Hi,

I was wondering if your code also works with the Arduino Nano 33 IoT. It doesn't give any errors when compiling. Output seems OK 11:07:12.328 -> LoRa init succeeded. 11:07:12.328 -> 11:07:12.328 -> LoRa Simple Node 11:07:12.328 -> Only receive messages from gateways 11:07:12.328 -> Tx: invertIQ disable 11:07:12.328 -> Rx: invertIQ enable 11:07:12.328 -> 11:07:12.328 -> Send Message! 11:07:12.396 -> TxDone 11:07:13.324 -> Send Message! 11:07:13.392 -> TxDone 11:07:14.349 -> Send Message! But when I check the Gateway I have (One from TTN, indoor model) I don't see any message arriving). Also not sure If I should see them, but I would like them to be visible somewhere. Trying to get this to work with TTN. The LIMC libraries give errors on the IRQ pins or something.

Using the Nano 33 IoT board with a LoRA RFM95C module/breakout from Adafruit Any thoughts on how to tackle this one? Kindest regards,

[IoTThinks]

Your gateway may be a LoRaWAN gateway. This library is LoRa.

They are not compatible.

[skuppens]

That’s true… My mistake, looked over that.

Thank you

Stijn

Van: IoTThinks.com notifications@github.com Verzonden: donderdag 2 april 2020 14:42 Aan: sandeepmistry/arduino-LoRa arduino-LoRa@noreply.github.com CC: Kuppens Stijn stijn.kuppens@kdg.be; Author author@noreply.github.com Onderwerp: Re: [sandeepmistry/arduino-LoRa] Arduino Nano 33 IoT (#355)

Your gateway may be a LoRaWAN gateway. This library is LoRa.

They are not compatible.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHubhttps://github.com/sandeepmistry/arduino-LoRa/issues/355#issuecomment-607822076, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AA6KDLW7O7DXOJ62RQCS24DRKSB2FANCNFSM4L2GCNJQ.