I am trying to flash a generic nRF52823 with the test sketch. When I flash the soft device, it says that the programming finished and the verification was successful. Here is the log:
Open On-Chip Debugger 0.10.0-dev-00254-g696fc0a (2016-04-10-10:13)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 0
0x4000
adapter speed: 10000 kHz
nrf52.cpu: target state: halted
target halted due to debug-request, current mode: Thread
xPSR: 0x61000000 pc: 0x0001b08e msp: 0x20001188
nrf52.cpu: target state: halted
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0xfffffffe msp: 0xfffffffc
** Programming Started **
auto erase enabled
nrf52.cpu: target state: halted
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000001e msp: 0xfffffffc
wrote 114688 bytes from file C:\Users\Admin\Documents\ArduinoData\packages\sandeepmistry\hardware\nRF5\0.7.0/cores/nRF5/SDK/components/softdevice/s132/hex/s132_nrf52_2.0.1_softdevice.hex in 2.602834s (43.030 KiB/s)
** Programming Finished **
** Verify Started **
nrf52.cpu: target state: halted
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0xfffffffc
nrf52.cpu: target state: halted
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0xfffffffc
verified 110636 bytes in 0.377083s (286.523 KiB/s)
** Verified OK **
** Resetting Target **
shutdown command invoked
That output leads me to believe that the sketch was uploaded successfully and the chip should start broadcasting over BLE. However, when I use a BLE scanning app, I don't see any device called "test". Is there anything else I need to do in order for the chip to start broadcasting?
I am trying to flash a generic nRF52823 with the test sketch. When I flash the soft device, it says that the programming finished and the verification was successful. Here is the log:
That output leads me to believe that the sketch was uploaded successfully and the chip should start broadcasting over BLE. However, when I use a BLE scanning app, I don't see any device called "test". Is there anything else I need to do in order for the chip to start broadcasting?