I am trying to upload a sketch to micro:bit V2.21 using ArduinoIDE and BSP 0.7.0, but I get a DAPLink related error and cannot upload. Please let me know how to deal with this.
I tried uninstalling and reinstalling the device in device manager to no avail.
Note that this board can be uploaded on a Linux PC, so I don't think it is a board failure.
Hardware : BBC micro:bit V2.21
Firmware : Version 0257
PC OS : Windows 11 22H2
IDE : Arduino IDE 1.8.19 (or 2.2.1)
BSP : Nordic Semiconductor nRF5 Boards by Sandeep Misty version 0.7.0
Boards : BBC micro:bit V2
Port : COM12(BBC micro:bit V2)
When connected to a PC, the following will appear in the device manager.
Ports(COM & LPT)
USB Serial Device(COM12)
Universal Serial Bus devices
CMSIS-DAP v1
CMSIS-DAP v2
WebUSB' CMSIS-DAP
The following error message appears.
Open On-Chip Debugger 0.10.0-dev-00254-g696fc0a (2016-04-10-10:13)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 2
Info : only one transport option; autoselect 'swd'
Warn : Transport "swd" was already selected
swd
adapter speed: 10000 kHz
cortex_m reset_config sysresetreq
Error: unable to find CMSIS-DAP device
Error: No Valid JTAG Interface Configured.
Error: No Valid JTAG Interface Configured.
I am trying to upload a sketch to micro:bit V2.21 using ArduinoIDE and BSP 0.7.0, but I get a DAPLink related error and cannot upload. Please let me know how to deal with this. I tried uninstalling and reinstalling the device in device manager to no avail. Note that this board can be uploaded on a Linux PC, so I don't think it is a board failure.
When connected to a PC, the following will appear in the device manager.
The following error message appears.