DPL-828 (Deprecated) Additional source plate for transfer into FluidX tubes

[KatyTaylor]

This has been absorbed back into https://github.com/sanger/limber/issues/1314, as I think it makes most sense to implement them both at the same time.

User story As a user of the scRNA Core Banking pipeline, I would like the option to use an additional source plate in the transfer from the "LRC PBMC Bank" plate to the "LRC Bank Stock" FluidX tubes, to cover the edge case where the wells in the source plate don't contain enough cells to fill a FluidX tube for sequencing.

Who are the primary contacts for this story Lesley, Katy

Who is the nominated tester for UAT Lesley

Acceptance criteria To be considered successful the solution must allow:

• [ ] I can scan an additional source plate when doing the transfer from the "LRC PBMC Bank" plate to the "LRC Bank Stock" FluidX tubes
• [ ] The custom pooling takes into account wells from both source plates
• [ ] The Hamilton driver file takes both source plates into account
• [ ] Add logic to prevent source wells from different samples (as indicated by the original vacutainer barcodes) being pooled into the same fluidx tube

Dependencies This story is blocked by the following dependencies:

• https://github.com/sanger/limber/issues/1314

[KatyTaylor]

N.B. Cardinal pipeline also had multiple source plates as a requirement but it never got implemented (https://github.com/sanger/limber/issues/770) - they actually use a workaround where they pool source wells --> destination tubes 1:1, and then use the poolings/new page in Sequencescape to pool the tubes together. Perhaps this strategy could be used for 007c, since the requirement for an additional source plate is an edge case?

[stevieing]

Closed as deprecated.