sareph / th9x

Automatically exported from code.google.com/p/th9x
Other
0 stars 0 forks source link

Plugging in a trainer cord turns on the controller, but doesn't trigger the PPM output. #115

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago
What steps will reproduce the problem?
1. Get a simulator that uses the JR trainer cord/protocol.
2. Configure a model for it on your controller (use PPM output protocol).
3. Turn the controller off.
4. Plug in the trainer cord to the simulator, and notice that the controller 
comes on, but there is no PPM output from it.

What is the expected output? What do you see instead?
When I plug in the trainer cord, I expect the controller to come on, and PPM 
output to be sent out via that cord.

What version of the product are you using? On what operating system?
r2413.

Please provide any additional information below.
I've been told, but not verified (sorry) that er9x does this properly. The 
sources were dissimilar enough that I couldn't see what might be causing such a 
difference.

Original issue reported on code.google.com by m...@mired.org on 10 Jun 2013 at 7:23

GoogleCodeExporter commented 9 years ago
revision r2413 does not exist in th9x

please remove the transmitter module and try again.

Original comment by th...@t-online.de on 10 Jun 2013 at 9:19

GoogleCodeExporter commented 9 years ago
My sincerest apologies. I thought I followed the link from the openrcforums to 
the openTx page, but obviously got th9x instead. I have no idea if th9x suffers 
from this issue. Please close this.

Again, my apologies for the erroneous report.

Original comment by m...@mired.org on 10 Jun 2013 at 10:13