Three values for expo when triple rates are assigned to the flight mode switch (ID0, ID1, ID2)

[GoogleCodeExporter]

What steps will reproduce the problem?
1.Currently, there are only two values for expo, one for each dual rate.
2.Since all rates formed in the mixers can be assigned to the flight mode 
switch (three position), it is possible to have 3 flight modes with separate 
rates for elevator, aileron, and rudder all on one switch, but it is only 
possible to assign two expo values.
3.Need to be able to add a third expo value to each of the primary controls 
when triple rates are assigned to the flight mode switch.  

What is the expected output? What do you see instead?
This would be very useful for 3D and pattern (F3A) flying. Could have separate 
flight conditions for normal flying, spins/snap rolls, and 3D.

What version of the product are you using? On what operating system?
R80, V1.1287

Please provide any additional information below.

Original issue reported on code.google.com by jalowe1234@gmail.com on 22 Jun 2010 at 3:29

[GoogleCodeExporter]

Should be listed as an enhancement

Original comment by jalowe1234@gmail.com on 23 Jun 2010 at 1:18

[GoogleCodeExporter]

Original comment by th...@t-online.de on 23 Jun 2010 at 7:31

• Added labels: Type-Enhancement
• Removed labels: Type-Defect

[GoogleCodeExporter]

Original comment by th...@t-online.de on 27 Jan 2011 at 12:02

• Changed state: Done