Which resistors instead of glued BF350?

scottbez1 / smartknob

Haptic input knob with software-defined endstops and virtual detents

https://www.youtube.com/watch?v=ip641WmY4pA

Other

19.33k stars 1.11k forks source link

Which resistors instead of glued BF350? #149

Open DennisCor opened 11 months ago

DennisCor commented 11 months ago

Hi, you wrote that in v0.5 you replaced the glued BF350 with footprints for SMD resistors. Which type of SMD resistors do I need to make it work with the HX711. Just default 330 ohm SMD?

DerSpatz commented 11 months ago

According to the schematic, yes. Footprint is 2510,

Bob0x00 commented 11 months ago

Is it ok to solder the resistor directly to the printed circuit board? Or do I need to apply some glue between the resistor and the printed circuit board? After soldering, I can't get the circuit to detect the press action, how do I troubleshoot this? Thank you very much!