scottlawsonbc / wii-esc

Automatically exported from code.google.com/p/wii-esc
1 stars 1 forks source link

Unable to open project #13

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago
Hi, I'm trying to open the project and it doesn't do anything. I've downloaded 
all the files from the source (all header files and so on),I've changed the 
compiler to avr-gcc and I've even made the same file hierarchy as in the 
repositorybut I just get a "Opening D:\Hobby\CodeBlocks\wii_esc_ng.cbp" message 
in Codeblocks log and it's like I didn't open anything.
What am I doing wrong? Is there another way or must I make a new project and 
start adding files?

Original issue reported on code.google.com by silviu.d...@gmail.com on 23 Apr 2014 at 12:06

GoogleCodeExporter commented 9 years ago
[deleted comment]
GoogleCodeExporter commented 9 years ago
Figured out the problem, all the files were in HTML format. Redownloaded the 
project with tortoise svn and everything is OK, I can compile the project. Now 
I have another issue, I select the corresponding board (RB50A) and flash 
everything when I power the esc instead of beeps the motor is doing some 
strange moves, like it's hitting something over and over again. If I disable 
the startup sounds the motor (NTM 3530 1400kv) starts with a little help but I 
can only go to 15-20% throttle and after that it stalls. I tried SimonK and 
BLHELI and the motor runs Ok but I have problems with very hard acceleration. 
With WiiESc the motor doesn't even start right and if it starts I have the 
maximum throttle issue.

Original comment by silviu.d...@gmail.com on 2 May 2014 at 5:38

GoogleCodeExporter commented 9 years ago
Hi, can you try pre-compilled HEX from here: 
https://googledrive.com/host/0Bzk5pgkwmev-b3ZLaWdQOEJGWUk/

Original comment by d.kayu...@gmail.com on 15 May 2014 at 4:45

GoogleCodeExporter commented 9 years ago
Hi, thanks for the reply but I forgot to mention one thing: I have a DIY ESC 
and the wiring is similar to the RB50A but the high side and low side signals 
are reversed so I cannot use a predefined hex file.

Original comment by silviu.d...@gmail.com on 15 May 2014 at 6:17