Closed yoyo42 closed 4 years ago
It is very hard to reach the back left adjustment screw because the extruder is moved to that corner between cycles. If the head was parked between the back left and back centre screws it would be a lot easier to reach..
This is configurable in the settings. Just change the movement gcode to your liking.
Thanks, adding an X65 to to the move gcode and lifting it 20mm higher makes it much easier to adjust.
It is very hard to reach the back left adjustment screw because the extruder is moved to that corner between cycles. If the head was parked between the back left and back centre screws it would be a lot easier to reach..