search

scottrini / OctoPrint-PrusaLevelingGuide

42 stars 6 forks source link

Not working after upgrading from mk3s+ to 3.5 #54

Open dac8767 opened 5 months ago

dac8767 commented 5 months ago

This plugin was working perfectly with mk3s+, but after upgrading to prusa 3.5, it on longer works. The printer will take its measurements, but nothing is transmitted to octoprint. I gets stuck at “waiting for mesh level to complete”

scottrini commented 5 months ago

This isn't intended to be used with the new boards. I have no plans to make any adjustments to support them. If someone else adds the support and submits a pull request, I'd review it.

jec0709 commented 5 months ago

Please update the firmware so that it works with MK3.5!!!! This feature you developed is why I use PRUSA Without this function, there is no point in using a PRUSA printer. please

abit11w commented 4 months ago

Bought the Sillicone Tubing etc. to do it on Prusa Mk3.5 but now its obsolete.

scottrini commented 4 months ago

The entire mod and process has been obsolete since 7x7 mesh bed leveling was added. This was built prior to that. There's no reason to update this for newer printers, but if someone wants to do it, I'm not going to stop them.

jec0709 commented 4 months ago 
    p{margin-top:0;margin-bottom:0}

That's good newsI would really appreciate it if you could make itI'll be looking forward to itDue to problems with MK3.5, I'm now trying a different way to level my buds.--------- 원본 메일 ---------

보낸사람: Scott Rini ***@***.***>
받는사람: scottrini/OctoPrint-PrusaLevelingGuide ***@***.***>
  참조: jec0709 ***@***.***>,Comment ***@***.***>
날짜: 24.05.16 05:32 GMT +0900

제목: Re: [scottrini/OctoPrint-PrusaLevelingGuide] Not working after upgrading from mk3s+ to 3.5 (Issue #54)

The entire mod and process has been obsolete since 7x7 mesh bed leveling was added. This was built prior to that. There's no reason to update this for newer printers, but if someone wants to do it, I'm not going to stop them.

—Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you commented.Message ID: @.***>

der-eine commented 4 months ago

Hello Scottrini,

I read that you believe this approach no longer makes sense for newer printers. However, the leveling process of the MK3.5 is no different from that of the previous printers in the series. Only from the MK3.9 onwards is there a load cell and thus automatic leveling. Perhaps you could reconsider your opinion and take another look at it. Thank you.