Not getting a temp readout - using Phidget 1048 - Artisan v.8.0 - Diedrich IR 12 - K-type wire.

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Not getting temp feed in software ...
2.
3.

What is the expected output? What do you see instead?

What version of the product are you using? On what operating system?

Using IMac with Mavericks. Artisan 8.0
Please provide any additional information below.
Also getting message on picture attached

Original issue reported on code.google.com by julian.t...@gmail.com on 5 Nov 2014 at 2:20

Attachments:

• image.jpg

[GoogleCodeExporter]

Did you install the Phidgets driver for OS X?

Original comment by luther.m...@gmail.com on 5 Nov 2014 at 2:36

[GoogleCodeExporter]

Nope... That would probably explain =) sorry. I'll give that a try. 

Also, BT and ET both show at -1 readouts. I'm guessing that download may fix 
all of that?

Can't wait to get this up and running! Love the interface

Original comment by julian.t...@gmail.com on 5 Nov 2014 at 2:53

[GoogleCodeExporter]

Just downloaded the phidget driver THANK YOU. Getting an actual reading now. 
However, ET is reading actual BT on the roaster and BT on Artisan is reading a 
fixed 826.9..

Original comment by julian.t...@gmail.com on 5 Nov 2014 at 2:59

[GoogleCodeExporter]

Switch the BT and ET wires on your Phidgets .Further, the BT seem to have the 
wires reverse. Note that the two wires of a probe are "orientated". Just swap 
the two wires of the BT probe to get the correct reading. I'll close this as 
this is not an Artisan software issue.

Original comment by luther.m...@gmail.com on 5 Nov 2014 at 3:27

• Changed state: Invalid

[GoogleCodeExporter]

I only have BT wires (from PID in roaster to phidget). 

Original comment by julian.t...@gmail.com on 5 Nov 2014 at 3:50

[GoogleCodeExporter]

If you have only one thermocouple connected, try moving that one to the 
connector next to it to move that BT signal to the real BT in Artisan. Short 
cut all the other three inputs (so always connect + and - on the Phidgets side) 
or just simply ignore that false reading (that is generated by the open 
dangling port) and deactivate the corresponding ET lcd and curve in Artisan 
(menu Config >> Device, tab ET/BT, first line).

Original comment by luther.m...@gmail.com on 7 Nov 2014 at 7:10

[GoogleCodeExporter]

Thank you for the help. I will give that a try. 

Original comment by julian.t...@gmail.com on 7 Nov 2014 at 6:35