I added a Easton 72M KWH meter to the smartevse (running firmware 1.8.0). After I discovered that the modus address needed to be above 010 (first 10 addresses are reserveert for multi smartEVSE sage) everything worked fine.
Only the display shows the power imported into the car wit a non round figure. The value is going over the drawing. As shown in the attached picture.
Hello,
I added a Easton 72M KWH meter to the smartevse (running firmware 1.8.0). After I discovered that the modus address needed to be above 010 (first 10 addresses are reserveert for multi smartEVSE sage) everything worked fine.
Only the display shows the power imported into the car wit a non round figure. The value is going over the drawing. As shown in the attached picture.
Gr. Remco