THANKS! Screw size and fan size?

sgofferj / CM3588-NAS-case

Creative Commons Attribution Share Alike 4.0 International

91 stars 6 forks source link

THANKS! Screw size and fan size? #3

Open njreid opened 6 months ago

njreid commented 6 months ago

Thanks so much for this super high quality case design. I printed the top and bottom and they fit the NAS board perfectly.

Just wondering if you could clarify which screws size you intended? The usual #6-32 UNC screws used when assembling PCs?

Also, it looks like your design has two cut outs for fans. Did you have some particular fans in mind?

sgofferj commented 6 months ago

I'm using M3 socket head for the PCB and countersink for the lid and fans. The fans I use are 40mm x10mm 5V. Noname at the moment but I'm planning Noctuas.