Hall sensor positioning not vorking with howerboard motor

shamansystems / Cheap-FOCer-2

Low-Cost Motor Controller based on the VESC 6

335 stars 79 forks source link

Hall sensor positioning not vorking with howerboard motor #30

Closed astra404 closed 3 years ago

astra404 commented 3 years ago

Hello, I tried to monitor the motor position by using hall efect sensors in 10" hoverboard motor (WT25HB36v20180408), but graph in vesc tool does not show anything. Can it be that vesc tool just not display this data (it shows im running in limited mode)? Or there is a probem somwhere else?

I mesured the signal from hall sensor with multimeter (gnd probe on gnd pin and sens probe on hall pin ) it shows 0.5v difrence when when I moove the motor. If it would help I can send a video and photos.

astra404 commented 3 years ago

Nevermind, after running hall efect sensor detection everything started to work fine. Also I didn't see the motor mode selection (it was set to sensorles :D).