search

simon-jouet / ESP32Controller

ESP32-based 3D printer controller
120 stars 29 forks source link

R2 routed? #7

Closed KanyonKris closed 5 years ago

KanyonKris commented 5 years ago

@simon-jouet, very nice project! The schematic looks nice. I opened the PCB layout and I see the part footprints but no traces, just the net lines. Is this correct or do I have something wrong?

simon-jouet commented 5 years ago

Hi @KanyonKris

Thanks, I haven't routed the R2 board because I'm still tweaking it a bit, if you want to see a routed version @Ringel pushed a MR for one. I haven't tried it but if you wait a bit @Ringel should be able to tell you if it works or not.

I've done few more Tweaks to the schematic since then and will continue a bit over the weekend. I also think I've found a decent layout so the next step will be to clean that up a bit and start the routing.

KanyonKris commented 5 years ago

Thanks for the reply. I'll check out Ringel's board and watch for your updates.

simon-jouet commented 5 years ago

closing #8