search

simonwex / faceshield

Face shield personal protective equipment (PPE)
Other
0 stars 0 forks source link

Validate prototype with SMG #6

Open simonwex opened 4 years ago

simonwex commented 4 years ago

Get feedback from local docs and ready a prototype for manufacturing.

simonwex commented 4 years ago

image

Feedback:

Works like a damn. I can't fog it up even if I breathe hard on the clear plastic when it is on.

Looking closely I can see the grooves in the plastic from the printing. Grooves can't be wiped. That being said, we'll figure out a bath cleaning.

It is both actually. Most of the time our heads will be bent downward when wearing so can't be long. I would say it is good for myself and I am average height. Rigidity is fine. It could be slightly more transparent.

I would work on ditching the bottom part. Less is better when it comes to infection control. I just took it off. Works just fine without. We're wearing gowns that will protect form stabbing when it is on.

simonwex commented 4 years ago

Yes. Any sharp angles are a concern for infection control.

If forced to push it through infection control I know that the 90 degree angles will be much more accepted than the sharp angles currently present.

revzimmer commented 4 years ago

What size is that plastic shield?

whomisi commented 4 years ago

If they're going to be bathing them, then what is stopping them bathing the ones they have already instead of throwing them out each day?

HarHarrison commented 4 years ago

image I believe these are the style being used currently, obviously can't be disinfected.

whomisi commented 4 years ago

Ok, in Salmon Arm I am told that have this style, and the standalone (similar to what we're looking at printing) style