Closed hartytp closed 4 years ago
Setting up the PI analysis takes a few hours of work so I do it only for complex circuits or critical rails. Here, we are copying power supply from already tested designs. I don't think it is necessary in this case.
Ok fair enough
Please can you
Then we can close
The power budget says that the 5V0A rail can draw up to 145mA, but the LT1761 is only a 100mA regulator...replace with a 3045 (thereby removing a BOM line)?
All other rails look fine (we're generally using 3A LDOs for rails drawing 100mA or so!).
NB if we add a new pre-amp we'll need to check the power budget on that rail...
good catch. Fixed
Did you mean to connect pins 1 and 2?
I did it already.
(if only to check power margin on LDOs etc)