search

sinara-hw / meta

Meta-Project for Sinara: Wiki, inter-board design, incubator for new projects
50 stars 4 forks source link

EEM front panels washer cutout. #3

Closed jordens closed 5 years ago

jordens commented 6 years ago

From @jordens on May 15, 2018 12:46

The cutouts that receive the rectangular snap-in grey plastic "captive" nipples for the panel mounting screws were too narrow on the older boards. The washer was squeezing the screw and not allowing it to move freely. More recent ones seem to be fixed. Has that fix been applied to all boards?

Copied from original issue: sinara-hw/sinara#547

jordens commented 6 years ago

From @gkasprow on May 22, 2018 21:39

Did you observe it only with first revision or later as well?

jordens commented 6 years ago

The cutout was too small for all board I received until a month ago. In the last batch there were still some panels with bad cutouts but those may have been from older runs. I just wanted to make sure all panels are updated. As a sidenote: receiving 8HP panels with 4HP handles (like for the last Kasli batch) is disappointing.

hartytp commented 5 years ago

@gkasprow I think this has been fixed on all boards now. Please confirm and close.

hartytp commented 5 years ago

@gkasprow ping...is this now fixed on all designs?

gkasprow commented 5 years ago

I think so.