Open dtcallcock opened 4 years ago
Hope you don't mind me moving this here as it is very interesting but orthogonal to thread it was in.
We can make a version with just DC jacks on the front panel and Molex connectors on the back panel if there is enough interest.
Or just a little adaptor PCB that hangs off that CPCIS connector and breaks it out into a bunch of Molex?
I'm not familiar with CPCIS connectors. Can anyone post an image?
Are there some public specs (yet)?
The project is very new. This is non-rad-hard version of this project We need such PSU for a few projects:
I updated the specs https://github.com/elhep/CPCIS-AC-PSU/wiki https://github.com/elhep/CPCIS-DC-PSU/wiki
update: the mechanical part is finished, both AC and DC PCBs are nearly done. There will be another super-simple version with DC jack and Molex connectors for backplane-less use cases.
Is ce compliance certification part of the roadmap? (And a reminder: we wanted to do the emi/emc compliance measurements for a typical Sinara system as well)
Yes, I have complete CE test equipment in my lab
While we're at it, it would be interested to measure the conducted emissions from Kasli.
This we can do easily. What exacly would you like to measure - what configuration, how ground loops connected, what interfaces, etc.
@gkasprow what about the preliminary EMTEST with a typical system (Kasli+backplane adapter, 3 DIO-BNC, Sampler. 2 Urukul, Zotino, Grabber, plus a couple IDC-BNC)? I know it's a lot of cables but I am sure this is worth it.
Yes, I remember. So far did not have a chance to collect the required HW in one place. These are so hot products that never stay on the shelves longer than w few days
From @gkasprow