Closed gkasprow closed 6 years ago
The bottom SMA (channel 7) interferes with the handle. To use it that channel, the handle needs to be removed.
hm, I connected the SMA a few times and didn't notice that. Can you take a pic ?
Will do.
maybe on my board the SMA connector was assembled at slightly different angle or I have smaller SMA nut :)
@jordens do you observe this issue on all boards you have? Maybe some cut-out in the handle would do the job? Not very elegant but if we make the connectors placed denser, we limit access space to them.
Yeah. I can wiggle it and file it off. It's on two out of three and the connector where the connector is at a slight angle. Could also be viewed as a QC issue. 8 SMA on 4 HP is too dense IMHO (but that's old news).
_Migrated to sinara-hw/DIOSMA#1