search

site2site / Studio-Xoup

An online infrastructure to stitch the Studio-X Global Network sites together into a single global interior through selective sharing in and with the public.
MIT License
1 stars 2 forks source link

design thermal printer casing #3

Open troyth opened 11 years ago

troyth commented 11 years ago

Design a casing for the thermal printer. Do NOT use any "Studio-X" logos or identity, it should be a generic case, but it can incorporate color (perhaps the color of the location it will be installed in).

@warshawshaw can help - he has a thermal printer.

mashalusha commented 11 years ago

Do you mean instead of the manufacturers casing or in addition to?

troyth commented 11 years ago

In addition! For inspiration: http://bergcloud.com/littleprinter/

mashalusha commented 11 years ago

cute! got it.Should I have some sketches for Thursday?

troyth commented 11 years ago

definitely!

On Mon, Nov 4, 2013 at 4:40 PM, Masha A. N. Drozdov < notifications@github.com> wrote:

cute! got it.Should I have some sketches for Thursday?

— Reply to this email directly or view it on GitHubhttps://github.com/site2site/Studio-Xoup/issues/3#issuecomment-27737642 .

Troy Conrad Therrien @troytherrien +1 (646) 831-6034

mashalusha commented 11 years ago

@warshawshaw can you tell me the dimentions of the thermal printer and send a photo if possible?

warshawshaw commented 11 years ago

Hey,

Sorry for the late reply. Here are the dimensions.

4"x2.25"x2" below this lip that runs around the top edge.

Lip is 4 3/8" x 2 9/16"

But a casing that it can fit into below the lip would probably work best. It needs a 1"x 1/4" opening on the back side of the bottom for cords to run through. To be safe it would be easiest to cut a slit that is 3/8" or 1/2" deep in the the rear side on the bottom. It's not centered; it should be 1 5/8" from the left side and 1 3/8" from the right side (measuring with the back/wires side up). It's kinda annoying without seeing it so you can borrow it for a while if you want. Is there a good time and place I can hand it off to you?

On Nov 6, 2013, at 7:13 PM, "Masha A. N. Drozdov" notifications@github.com wrote:

@warshawshaw can you tell me the dimentions of the thermal printer and send a photo if possible?

— Reply to this email directly or view it on GitHub.

mashalusha commented 11 years ago

Thanks. If you can send me a picture it would be amazing.... Or can i find one online? I left back to NJ already.... I will be in class tomorrow. Can you bring it in?

troyth commented 11 years ago

I believe it's this one: http://www.adafruit.com/products/597

On Wed, Nov 6, 2013 at 9:16 PM, Masha A. N. Drozdov < notifications@github.com> wrote:

Thanks. If you can send me a picture it would be amazing.... Or can i find one online? I left back to NJ already.... I will be in class tomorrow. Can you bring it in?

— Reply to this email directly or view it on GitHubhttps://github.com/site2site/Studio-Xoup/issues/3#issuecomment-27932990 .

Troy Conrad Therrien @troytherrien +1 (646) 831-6034