Support, infill, bridge speed don't have percentage settings
If the settings would support percentages, I could just set the perimeter speed using a shortcut and be done.
If Support had the shortcut I could just set all the speeds to the same value (instead of printing TPU too fast because I didn't remember to change that setting.)
Currently I need to open the setting in order to change the support speed and then I'll forget to change it back.
Version
1.3.1-18ddd3a (Appimage downloaded 2021-11-07)
Operating system type + version
OpenSuse Tumbleweed
Missing speed settings:
If the settings would support percentages, I could just set the perimeter speed using a shortcut and be done. If Support had the shortcut I could just set all the speeds to the same value (instead of printing TPU too fast because I didn't remember to change that setting.)
Currently I need to open the setting in order to change the support speed and then I'll forget to change it back.
BTW: This is a 404: http://meta.stackexchange.com/a/259196 http://nickohrn.com/2013/09/write-great-feature-request-bug-report/