Open xiaguangbo opened 4 months ago
Is there a configuration available？ I used the 'd1-wip' branch and tried to imitate defconfig, but it was all problematic
defconfig
U-Boot SPL 2024.01-rc1-45338-g2e89b706f5-dirty (Jul 10 2024 - 16:53:42 +0800) size=30, ptr=11b0, limit=4000: 41180 size=98, ptr=1248, limit=4000: 411b0 size=18, ptr=1260, limit=4000: 41248 ofnode_read_u32_array: ranges: fdtdec_get_int_array: ranges get_prop_check_min_len: ranges bind node cpu@0 - attempt to match compatible string 'thead,c906' - attempt to match compatible string 'riscv' - found match at 'riscv_cpu': 'riscv' matches 'riscv' size=98, ptr=12f8, limit=4000: 41260 size=20, ptr=1318, limit=4000: 412f8 fdtdec_get_addr_size_auto_parent: na=1, ns=0, fdtdec_get_addr_size_fixed: reg: adx ofnode_read_u32_index: timebase-frequency: (not found) ofnode_read_u32_index: timebase-frequency: x (24000000) size=30, ptr=1348, limit=4000: 41318 size=98, ptr=13e0, limit=4000: 41348 clk_set_defaults(cpus) clk_set_default_parents: could not read assigned-clock-parents for 411b0 ofnode_read_prop: assigned-clock-rates: <not found> clk_set_defaults(cpu@0) clk_set_default_parents: could not read assigned-clock-parents for 41260 ofnode_read_prop: assigned-clock-rates: <not found> fdtdec_get_int: #clock-cells: x (1) Looking for clock-controller@2001000 Looking for clock-controller@2001000 - result for clock-controller@2001000: clock-controller@2001000 (ret=0) - result for clock-controller@2001000: clock-controller@2001000 (ret=0) clk_of_xlate_default(clk=47f28) clk_request(dev=40968, clk=47f28) clk_enable(clk=47f28) sunxi_set_gate: (CLK#132) off#0xd04, BIT(31)om 2.9 | VT102 | 脱机 | ttyUSB0 clk_free(clk=47f28) size=8, ptr=13e8, limit=4000: 413e0 clk_set_defaults(dram-controller@3102000) clk_set_default_parents: could not read assigned-clock-parents for 40bf8 ofnode_read_prop: assigned-clock-rates: <not found> sunxi_ram_probe: dram-controller@3102000: probing DRAM BOOT DRIVE INFO: V0.24 DRAM CLK = 528 MHz DRAM Type = 2 (2:DDR2,3:DDR3) DRAMC read ODT off ofnode_read_prop: tick-timer: <not found> size=8, ptr=13f0, limit=4000: 413e8 ZQ value = 0x2f DDR efuse: 0xa DX0 state: 3 DX1 state: 0 ERROR: auto scan dram rank & width failed auto_scan_dram_config() FAILED DRAM init failed spl_board_init_f() failed: -19 resetting ... reset not supported yet ### ERROR ### Please RESET the board ###
Is there a configuration available？ I used the 'd1-wip' branch and tried to imitate
defconfig, but it was all problematic