07/09/24

[badeaa3]

Goals:

• [ ] 1. work with Cristian to validate IP1
• [x] 2. work with Ben/Cristian to validate mapping
• [ ] 3. get cost estimate for NI system

[badeaa3]

Goal 1

Goals for today:

• 1st routine
  • test 3/4 (push slow or fast 1 MHz (divide by 100) clock to the configOut)
  • write/read STATIC 0 and 1 then execute test 3/4 to see the clocks on the scope
• 2nd routine
  • test 1 program all 5188 bits using fast clock
  • program array 0 (4096) and array 1 (5188-4096). write/read back from ARRAY 0 and 1 and then execute test 1 in loopback mode to see it from OP_CODE_R_DATA_ARRAY_0 and OP_CODE_R_DATA_ARRAY_1

In the future:

• 3rd routine
  • test 2 program all 5164 bits using fast clock and then clock changes to slow clock for last 24 bits

[badeaa3]

Goal 2

Done and written in the test manual. Validated by using a voltmeter to check that connecting two pins that we think should be connected creates a closed circuit (hear a beep) or an open circuit (no beep). The two pins are on the DUT and level shifter.

Cristian is updating the firmware for this mapping.

[badeaa3]

Goal 3