search

smith3d / Marlin

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
http://marlinfw.org
GNU General Public License v3.0
96 stars 32 forks source link

filament runout sensor #33

Open menthol1960 opened 3 years ago

menthol1960 commented 3 years ago

Hello

I have an issue with the filament run out. I am using E3V2-2.0.x.17-Fast-5x5-180321 version cable checked metered etc.

The issue is that it cleans nozzle Then goes to print and the run out sensor triggers even though filament still present any advice would be appreciated

OhadHenn commented 3 years ago

I have this issue two, same printer

defetzer commented 3 years ago

same, also with the inverted version.No print possible.

arxcruz commented 3 years ago

Same problem, I even tried to change the FIL_RUNOUT_STATE to LOW but same problem

Sersch97 commented 3 years ago

same here, tried the normal and the inverted version but it still always retracts and waits

ulivero commented 3 years ago

Hi , I have the same problem too, i have an ender 3 v2 , board 4.2.2 with bltouch and folament runout sensor Withe the version of firmware slow, fast and inverted they all do the same , start print pause the print unload the filament , its not working , theres any solution to this ? i think the have to compile another firmware with this fix . any have a solution to this? thanks in advance

Thierry-56 commented 3 years ago

I am using Smith3D-E3V2-2.0.x.17-427-Fast-5x5-180321 version and I have the same problem: start print, pause the print and unload the filament Thanks in advance

galluccib commented 3 years ago

Same here.... start print, pause the print and unload the filament

galluccib commented 3 years ago

Same on 4.2.2 - Smith3D-E3V2-2.0.x.17-427-Fast-5x5-180321

ulivero commented 3 years ago

Hi again , anybody has a fix for this of filament runout pause the print and unload the filament ? Thank you so much

rembhu commented 3 years ago

... and another one with this problem who waits for solution.

N3tYaroz3 commented 3 years ago

I'm here for it too :)

Zaaap commented 3 years ago

Same here for Smith3D-E3V2-2.0.x.17-Fast-5x5-180321.bin

vcrproszek commented 3 years ago

I had the same problem. Simth recommend to use Jyers firmware now, so I did it, and now sensor is working properly https://github.com/Jyers