search

softerhardware / Hermes-Lite2

A second generation low-cost amateur HF software defined radio transceiver.
http://www.hermeslite.com
230 stars 78 forks source link

CN4 (SJ1-3525N) Will not sit flat on PCB #80

Closed kf5kog closed 6 years ago

kf5kog commented 6 years ago

This part will not sit flat on PCB. Based on mechanical drawing is shows a cutout required for the round section of jack. There are 2 other possible solutions. Find a different part or remove the alignment pin holes so the jack will sit on those pins. This will allow clearance for the jack housing. I just filed a flat spot on the bottom plastic. The round metal edge doesn't require filing, just the plastic area just behind it. cn4 jack

softerhardware commented 6 years ago

Added board cutout in hl2b6, 2/18/2018.