I noticed that there was no version for the V6/R6 SB Printhead variant, so I ported the changes over from the Revo variant. Haven't printed it yet, but it should work as well as the other variants.
It may be worth reexporting the STLs from the STEPs, as freecad's STLs can look a little rough. Though I don't think it's anything that would show up in a print.
I noticed that there was no version for the V6/R6 SB Printhead variant, so I ported the changes over from the Revo variant. Haven't printed it yet, but it should work as well as the other variants.