search

sorted01 / Filametrix

This is a mod of the Voron Stealthburner which adds a filament cutting possibility!
332 stars 44 forks source link

Issue with motors skipping because of too much pressure applied on the lever #33

Open seacred opened 7 months ago

seacred commented 7 months ago

While cutting sometimes the AB Motors skip because of the high pressure applied on the lever. Using nema 17 with 1A currently. Did somebody noticed the same behaviour?

appleimperio commented 5 months ago

do you manage to solve this? I'm having the same issue

seacred commented 5 months ago

I wasn't able to solve this issue by now. i tried to reduce the cuttingmovespeed to a minimum but ist working for some cuts and suddenly it will skip. not reliable cutting over some swaps and longer prints possible by now.

slightlysketch commented 2 months ago

so i had this issue too, fixed it by doing a few different things

one i swapped out my 36-40 motors for some 42-40s next i changed the run current to 1.0

if youre still skipping motors after that, its a set up issue and your plunger might be too long. need to be very precise

seacred commented 1 month ago

fixed it by using a setting up a gcode, which turns up the motorcurrent during cutting and resets it to default afterwards